The engine is an essential component of your car. Maintaining it in perfect condition enhances your safety and ensures a more comfortable ride. The engine coolant also has a role to play. It discharges heat during operation, ensuring that your engine stays cool. However, its effectiveness fades quickly, and you should flush your cooling stem often. How can I flush my car’s cooling system? Read on for tips.
- Acquire all you need
Flushing a vehicle’s cooling system is a simple procedure that you can perform at home. You can also seek Natrad air conditioning services to restore the right levels of refrigerant gas in your system. If you plan to do it yourself, acquire all the necessary tools and follow the instruction manual.
Here’s what you need;
- Safety gloves
- Drain pan
- 5 gallons of distilled water
- Empty lid buckets
- Pliers
- A coolant specific to your car
- Socket
- Cool your car engine& Empty the drain plug
Park your vehicle safely, and allow the engine to cool off. This is important since you’ll perform the process under the hood of your vehicle. Turn off the ignition and the car parking brake.
- Locate the radiator
Once your engine has cooled down completely, open the hood of your vehicle. Look under and try to locate the radiation in the engine bay. Moreover, examine the radiator’s bottom, and you’ll find a petcock or a drain sprout. To reach the sprout is a screwdriver to remove the splash shield.
- Open the drain sprout
It’s now time to open the rain sprout. Do this slowly and fit an empty bucket beneath. Ensure that the pail has a capacity of holding two gallons or more to avoid spoilages on the ground.
Open the sprout manually or use pliers. Once you loosen the sprout cap, also lift the radiator cap to increase the coolant’s flow into the pail and allow it to drain completely.
- Close the drain plug& Fill the cooling system with water
Put back the petcock and fill the cooling system with water. Also, put back the radiator cap, start your engine and allow it to run for about five minutes. Also, find out about the quarts that your cooling system can hold. Nowadays, most coolants are pre-diluted with water, and you should know what you need.
- Inspect the pressure system
Replace the pressure cap and allow your engine to run when the heater is on. Set the heater on high temperature until the gauge reaches its normal. Moreover, inspect the system pressure and turn off the engine. Once done, compress the upper radiator hose to ascertain whether the system has pressurized as required.
- Clean up!
Shut off the engine and clean it. Store the unused coolant safely away from children and pets. For the contaminated clothes and rugs, put them in plastic bags and dispose of the garbage bin.
Final thoughts
Are you wondering how to flush your car’s cooling system at home? Follow the ideas discussed above, and enjoy a more relaxed and comfortable ride. But, if the cooling system turns low in a few days, have a professional check the system.